L68111 bearing dimensions & suffix variants

TIMKEN L68111 — individual cup dimensions

TIMKEN L68111 is an individual tapered-roller cup (outer ring), not the complete cone-and-cup bearing. The manufacturer lists outside diameter D = 59.974 mm (2.3612 in) and outer-ring width C = 11.938 mm (0.4700 in).

Use the component number correctly

• D is the nominal cup outside diameter. C measures this outer ring only; it is not the assembled bearing width T. This single-cup record does not establish a shaft bore d or a matching cone.
• Preserve the full component number and its suffix. A shared prefix, similar ring size or a related-products suggestion does not approve a cone/cup combination or a cross-brand replacement.
• For a complete bearing, check both component markings and the manufacturer’s assembled d×D×T record. B+C is not a valid way to calculate T. A seal, axle rating, vehicle application and tightening procedure need their own evidence.
• Optional measurements with inconsistent printed metric and inch values are omitted from this supplement: Housing Backing Shoulder Dia. - Frontface (Da). Verify the manufacturer drawing before using these particular limits.

Factual reference: Timken official individual-component catalogue; source snapshot 2026-10-02. Original interpretation by BearingScope. These measurements do not certify a complete assembly, fit or interchange.

TIMKEN L68111 — bearing pairs and set identification

For TIMKEN L68111, the component number alone does not establish every dimension of a complete bearing. This reference identifies documented cone/cup combinations that contain L68111; select the row matching both of your component markings.

Which components make up the set?

What to confirm before using this reference

• d is the cone bore, D is the cup outside diameter and T is the complete bearing width for the exact pair. B and C measure the separate rings; do not add B and C to calculate T.
• No independently verified assembled d×D×T row is available in this supplement for this exact pairing. The component association is documented, but an assembled size must not be calculated from individual ring widths.
• A component may appear with several mating numbers. A match here documents that exact Timken combination; it does not approve other suffixes, mixed-brand rings, a vehicle application or a substitute with similar dimensions.
• A cone-and-cup set is not automatically a complete wheel-end repair kit. Seal numbers, collars, spacers and quantities must be confirmed separately unless the specific set note below explicitly lists them.
• For replacement work, inspect and replace the mating cup and cone together as specified for the assembly. Retaining a worn ring or mixing manufacturer geometries can change the contact pattern even when nominal diameters match.
• An axle tightening torque, preload or endplay target cannot be derived from these dimensions. Use the procedure for the identified hub or machine, including any pre-adjusted system restrictions.

Manufacturer references: Timken Bearing Specification Guide, Order 7534 (2002, archived distributor-hosted copy); Timken MileMate set chart, Order 5523 (May 2024), where listed; Timken cup-and-cone replacement guidance, Order 10832 (2016). Sources checked 2026-10-02. Measurement rows and set identities are kept separate by edition. BearingScope provides independent identification guidance, not sales or installation certification.