NSK 2322K dimensions and model data
NSK 2322K is a listed self-aligning ball bearing with a 1:12 tapered bore. Its catalogue boundary dimensions are 110×240×80 mm (nominal bore d × outside diameter D × width B).
Bore construction and mounting
The K suffix on 2322K identifies a 1:12 tapered bore, not a clearance or precision grade. The listed 110 mm bore is a nominal bearing dimension; it is not a specification for a straight shaft or an adapter sleeve bore. Match the mounting arrangement and verify residual internal clearance using the applicable mounting instructions.
Using the model-specific load factors
For radial load Fr greater than zero, first compare Fa/Fr with e = 0.37. Use loads in one consistent unit. When Fa/Fr ≤ 0.37, the catalogue dynamic equivalent load is P = Fr + 1.7Fa. Above that threshold, P = 0.65Fr + 2.6Fa. The static equivalent load is P0 = Fr + 1.8Fa. These are catalogue calculation rules for this bearing family, not a complete application approval.
Selection limits and missing specifications
- Cr = 233 kN and C0r = 94.5 kN are rated calculation values, not interchangeable maximum working loads.
- The listed speed limits are 2200 r/min with grease and 2800 r/min with oil. They are lubrication-qualified references, not a guaranteed machine operating speed.
- This bearing family accommodates angular misalignment through its spherical outer-ring raceway. It is not a high-axial-load substitute for a thrust bearing.
- NSK gives an approximate family-level misalignment range of 4° to 7° under normal loads. Adjacent shoulders, seals and other surrounding parts can reduce the available angle; this is not a model-specific allowable-angle guarantee.
- The mounting table uses da as a minimum, Da as a maximum and ra as a maximum. These are adjacent-part constraints, not alternative bearing dimensions.
- Precision class, internal clearance, cage material and a particular lubricant are not established for this individual designation by the model row. No missing value is treated as zero.
- The mass value is published once for the shared cylindrical/tapered catalogue row. A separate measured mass for the K variant is not supplied here.
- NSK flags this model for balls projecting beyond the bearing face: b1 = 0.5 mm. Check adjacent-part clearance rather than assuming the entire rolling element stays within width B.
Technical basis:NSK Rolling Bearings for Industrial Machinery, E1103d (2025), Part C, C122–C123 and introduction C116; source checked 2026-10-01. Values are independently organised for reference and comparison, not sales or an installation approval.
Dimension search·Bearing load calculator·NSK model reference