62012 bearing dimensions & suffix variants
Look up recorded dimensions for designations beginning with 62012. The table retains complete manufacturer designations so special suffixes and different dimensional variants remain visible.
On this page5 sections ⌄
Find by measured dimensions
Enter bore d, outside diameter D and width B. Use decimals or inch fractions such as 1/2 or 1 1/4.
No exact model evidence for 62012
No complete marking or clearly separated suffix variant matched this number. Related prefix results below must not be treated as this model's dimensions. Preserve the full manufacturer marking and its separators; a closure suffix such as 2RS is not an extra digit in the base number.
Related prefix matches — other model numbers may appear
These discovery results can contain a longer number or a different component. They are not specifications for the requested exact model. Open the complete product to inspect its original geometry.
6201-2NKE9
Deep groove ball bearing
View full technical record →NACHI6201-2NSE9
Deep groove ball bearing
View full technical record →KOYO6201 2RD
Deep groove ball bearing
View full technical record →TIMKEN6201-2RS
Deep groove ball bearing
View full technical record →KOYO6201 2RS
Deep groove ball bearing
View full technical record →SKF6201-2RS2/C3LHT23
Deep groove ball bearing with seals or shields
View full technical record →TIMKEN6201-2RS-C3
Deep groove ball bearing
View full technical record →SKF6201-2RSH
Deep groove ball bearing with seals
View full technical record →SKF6201-2RSH/C3
Deep groove ball bearing with seals
View full technical record →SKF6201-2RSH/C3GJN
Deep groove ball bearing with seals
View full technical record →SKF6201-2RSH/C3LHT23
Deep groove ball bearing with seals
View full technical record →SKF6201-2RSH/C4
Deep groove ball bearing
View full technical record →Check the drawing before substituting
Nominal dimensions are not shaft-fit tolerances. Different variants can add grooves, flanges, wider rings or assembly components. When the table has different dimensions, the complete designation—not the shared prefix—controls.
Reference basis & data limits
Manufacturer terminology is retained in the product records. Technical reference basis: JTEKT Basic Bearing Knowledge (boundary dimensions, tolerance classes and lubrication); NSK Bearing ABCs (lubrication, designations and clearance); NTN technical FAQs (closure codes and component interchange); SKF rolling-bearing selection and maintenance references.
Selection workflows and catalogue grouping are BearingScope editorial aids. Verify the current drawing and application requirements before using a candidate. Missing database information is not converted into an assumed match.