499502H bearing dimensions & suffix variants
Look up recorded dimensions for designations beginning with 499502H. The table retains complete manufacturer designations so special suffixes and different dimensional variants remain visible.
On this page5 sections ⌄
Find by measured dimensions
Enter bore d, outside diameter D and width B. Use decimals or inch fractions such as 1/2 or 1 1/4.
499502H — PEER catalogue dimensions
Independent technical reference from PEER’s historical 2009 sheets; checked 2026-10-03. These are catalogue records, not current-stock claims or replacement approvals. Printed units are kept separate.
| Full catalogue model | d×D×B (mm) | d×D×B (in) | Closed width / execution scope |
|---|---|---|---|
| PEER · 6200 series499502H | 15.875× | .6250× | Base designation only; complete closure execution must be checked |
Read ratings without transferring them to another execution
Cr and Cor are catalogue basic load ratings, not allowable application loads. Oil/grease values below are explicitly for open bearings where supplied. They are not sealed-bearing or machine operating-speed approvals. A dash means withheld or not established here.
| Model | Dynamic Cr / static Cor | Open: oil / grease | Evidence boundary |
|---|---|---|---|
| 499502H | 7740 / 3732 N | 26000 / 20000 r/min | Base-row catalogue values only; no cross-brand transfer. |
Printed decimal conversions inherit catalogue rounding; more decimal places do not create manufacturing accuracy. Special bores must not be rounded to a nearby metric bearing. The historical table does not establish an exact RS/2RS, NR, ABEC, C3, ceramic, vehicle or kit execution unless explicitly listed. No CAD or interchange approval is implied.
Related prefix matches — other model numbers may appear
These discovery results can contain a longer number or a different component. They are not specifications for the requested exact model. Open the complete product to inspect its original geometry.
Check the drawing before substituting
Nominal dimensions are not shaft-fit tolerances. Different variants can add grooves, flanges, wider rings or assembly components. When the table has different dimensions, the complete designation—not the shared prefix—controls.
Reference basis & data limits
Manufacturer terminology is retained in the product records. Technical reference basis: JTEKT Basic Bearing Knowledge (boundary dimensions, tolerance classes and lubrication); NSK Bearing ABCs (lubrication, designations and clearance); NTN technical FAQs (closure codes and component interchange); SKF rolling-bearing selection and maintenance references.
Selection workflows and catalogue grouping are BearingScope editorial aids. Verify the current drawing and application requirements before using a candidate. Missing database information is not converted into an assumed match.